Antenna Design Rating 0 Technical Support Guide ​​​​      Basic Definitions of Antennas  ​Antennas can transmit as well as.......

Question:  How many channels can I build by cascading splitters?      Answer:  Up to about 50 channels are possible.......

Question:  Which coax types are approved for the antenna lines?  Answer:  The manual provides length tables for RG58 and RG213;.......

Question: Does the APS4 feed active antennas? Answer: Yes - each antenna input delivers 12 V DC for up to three active components.......

Question:  How high should floor‑stand antennas be? Answer:  Raise the boom so the antenna sits at least 1.8 m above the.......

​Question:  How do I set the CLA DIP switches?  Answer:  Remove the logo cover and set switches according to Table 1.......

Question:  What is the CLA switch bank for?  Answer:  It lets you match the antenna inputs to long cable runs.......

Question:  Will a short circuit on one output disable all receivers?  Answer:  No - only the receiver on the shorted jack.......

Question:  What spacing is recommended between two diversity antennas?  Answer:  Place them at least 20 cm apart and within direct line‑of‑sight.......

​Question:  What triggers the red ERROR LED?  Answer:  The red LED appears if the antenna input voltage falls below 2 V.......

Question:  When should I use the LINK A/B TO PS connectors?  Answer:  Use them to pass both antenna signals on.......

Question:  How many wireless receivers can one APS4 serve?  Answer:  Each APS4 feeds antenna signals and DC power to up.......

Question:  How close can antennas be to walls or ceilings?  Answer:  Keep at least 10 cm in front of walls and.......

​​​​​​​​​Question:  Does the APS4 NONE come with a power supply?  Answer:  No, the APS4 model “NONE” does not include a power supply.A power supply.......

Question: What does the blue OK LED show? Answer: It lights while the corresponding antenna input is delivering correct DC.......

​Question:  How much current can each antenna output jack supply?  Answer:  Each of the eight outputs can source up to.......

​Question:  What is the correct power‑up sequence?   Answer:  Switch on transmitters first, then the APS4 and connected receivers together.......

​Question: Can two splitters fit side by side in a rack?   Answer:   Yes - the half‑rack chassis lets you mount.......

​Question:  When is an ASU4000 remote adapter required?   Answer:  Insert an ASU4000 if long cables or combiners drop the.......

​Question:  What power adapter does the APS4 need?   Answer: Operate the splitter only with a regulated 12 V DC, 3.5 A supply........

Question:  Which UHF frequencies does the APS4 cover?   Answer:  It is wide‑band and works from 470 MHz to 952 MHz.....