Using a ZC-9 as a Program Change Selector with the DriveRack 260

Table of Contents

Question: Answer:

Question:

How do I setup my ZC-9 as a program change with the DriveRack 260?

Answer:

Walk through of getting your ZC-9 setup with the dbx DriveWare software

Assign a ZC-4 under the Zone Controller section in Utilities. Make sure to match the 'Panel' # with the ID dip switch # on the side of the ZC-9 controller.

Below shows which binary # corresponds to each position on the ZC-9.

Binary 0 = Position A

Binary 2 = Position B

Binary 3 = Position C

Binary 5 = Position D

Binary 6 = Position E

Binary 8 = Position F

Binary 10 = Position G

Binary 11 = Position H