DX-TX HDCP
Table of Contents
Question:
How to set HDCP on the DX-TX?
Answer:
Use the following commands:
?VIDIN_HDCP
?VIDIN_HDCP - Requests the video HDCP compliance of the video input port addressed by the D:P:S.
IMPORTANT:
Send command to Port 7.
Syntax:
SEND_COMMAND <DEV>,"'?VIDIN_HDCP'"
Example:
SEND_COMMAND dvTX,"'?VIDIN_HDCP'"
Returns a COMMAND of the form: VIDIN_HDCP-<ENABLE|DISABLE>
VIDIN_HDCP
VIDIN_HDCP - Sets the video input HDCP compliance setting of the video input port addressed by the D:P:S.
CAUTION:
For sources (such as DVD and Blu-Ray players) that do not support non-compliant displays, disabling the HDCP
compliance is not recommended and may affect DXLink performance.
IMPORTANT:
Send command to Port 7.
NOTE:
When VIDIN_HDCP is disabled, the addressed video input will appear to any source as not being HDCP compliant. For PC sources that encrypt all video when connected to an HDCP compliant display, disabling HDCP compliance on the input will cause the PC to send non-encrypted video which can then be routed to non-compliant displays and video conferencing systems. This command is not applicable to the analog video port.
NOTE:
After changing this setting, it may be necessary to disconnect and re-connect PC
sources.
Syntax:
SEND_COMMAND <DEV>,"'VIDIN_HDCP-<ENABLE|DISABLE>'"
Example:
SEND_COMMAND dvTX,"'VIDIN_HDCP-ENABLE'"
Enables the HDCP Compliance of video input port (#1 based on D:P:S).
Table of Contents